We have a SIEM product that gathers all logs from the servers and this allows us to correlate events.
#Show mac address cisco router windows
We are running windows 2012 R2 for our DHCP servers. I have a quick question about logging new mac addresses in syslog. With proper skill, this method will allow you to find hosts in a network of any size in no more than a couple of minutes without even away from your workplace.Good morning Reddit! I hope everyone is doing well. Holdtime : 144 secNow you should connect to the neighbor switch SW -DELTACONFIG-2 with the running address 192.168.1.202 and find the necessary MAC address there. Interface: GigabitEthernet0/1, Port ID (outgoing port): GigabitEthernet0/18 Platform: cisco WS-C2960-24TT-L, Capabilities: Switch IGMP
Port ID ( Gig 0/18) – the interface of the neighbor switch. Local Intrfce ( Gig 0/1) – the local interface where the neighbor switch is connected to S - Switch, H - Host, I - IGMP, r - Repeater, P - Phoneĭevice ID Local Intrfce Holdtme Capability Platform Port IDĭevice ID ( SW-DELTACONFIG-2) – the name of the neighbor device The sh cdp neighborsdetail command will additionally show the IP addresses for controlling the neighbor switches.Ĭapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge The command will show you names and related ports of all the Cisco switches that are connected to the current switch. If you have several switches in your office, use the sh cdp neighbors command to determine the name and address for running the neighbor switch. In this case, you should repeat search in the MAC addresses table of the neighboring switch. Sometimes, another switch is connected to the found port of the current switch. But if there are several switches in the network, it’s possible that you found not the final one. If you have a small office and all network is organized only using one switch, your search is finished.
The output line shows that the host is located in VLAN 10 and is connected to a port of the Gigabitethernet 0/1 switch. SW-DELTACONFIG-1# sh mac address-table | inc 74f2 Usually, four last symbols will be enough. For more convenience, you can filter the necessary МАС address. Usually, there are a large number of records shown at this table. The show mac address-table command (it can sometimes be written with an additional hyphen instead of a space, like this: show mac - address-table) shows the MAC address table of all active devices that are connected to the switch. Having determined the device’s MAC address, you can keep on searching for its direct location on the switch. Protocol Address Age (min) Hardware Addr Type Interface The ARP table on these devices will contain the compliance of the MAC and IP addresses.įor searching, use the sh arp | inc x.x.x.x command, where x.x.x.x is the IP of the host we need. It’s possible if you have access to a Cisco router or Cisco ASA firewall which is the default host gateway.
The point is that each switch stores information about all MAC addresses that showed at least any network activity in the last few minutes. To do it, you don’t have to look for it visually. In everyday work, it’s often necessary to determine the switch and port a user or device is connected to.
0 kommentar(er)
